Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
DRYER EXHAUST TO RIGHT, LEFT
OR BOTTOM CABINET
WARNING -
THIS EXHAUST INSTALLATION, BE SURE TO
DISCONNECT THE APPLIANCE FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR HANDS
AND ARMS FROM SHARP EDGES WHEN
WORKING INSIDE THE CABINET. BE SURE TO
WEAR GLOVES
For downward venting, rotate elbow
sections so that elbow points downward
REMOVE
DESIRED
KNOCKOUT
(ONLY 1)
Installation Instructions
BEFORE PERFORMING
C
H
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT OR RIGHT SIDE OF
CABINET
• For side ducting, remove the knockout (ONLY 1).
Rotate elbow sections so that the points to the side.
Preassemble 4" elbow with 4" duct. Use only 4" UL
approved rigid metal for ducting inside the dryer.
• Insert duct assembly through the side opening and
connect to the internal elbow.
CAUTION:
the electrical wires inside the dryer when inserting
the duct.
4" UL approved rigid metal
• Apply duct tape as shown on the joint between the dryer
internal duct and the straight duct pipe.
9
Be sure not to pull or damage
C
H
DUCT
C
H
TAPE
CAUTION:
Internal duct joints must be
secured with tape, otherwise
they may separate and cause
a safety hazard.
Publicité
Table des Matières
