Automatic Heat Up; Powerboost - Electrolux Y82IS443 Notice D'utilisation

First set the heat setting for one of the left
side cooking zones.
To activate the function: touch
change the heat setting touch one of the
control sensors.
To deactivate the function: touch
cooking zones operate independently.

6.7 Automatic Heat Up

Use the function to get a desired heat setting
in a shorter time. When the function is on, the
cooking zone operates at the highest heat
setting in the beginning and then continues to
operate at the desired heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch (
touch a desired heat setting. After 3 seconds
comes on.
To deactivate the function: change the
heat setting.

6.8 PowerBoost

This function makes more power available to
the induction cooking zones. The function
can be activated for the induction cooking
zone only for a limited period of time. After
this time the induction cooking zone
automatically sets back to the highest heat
setting.
Refer to "Technical data"
chapter.
To activate the function for a cooking
zone: touch .
To deactivate the function: change the
heat setting.
6.9 SenseBoil®
The function automatically adjusts the
temperature of water so that it does not boil
over once it reaches the boiling point.
80 ENGLISH
. To set or
. The
comes on). Immediately
comes on.
If there is any residual heat (
/ ) on the cooking zone
you want to use, an acoustic
signal is emitted and the function
does not start.
1. Touch to activate the hob.
2. Touch to activate the function.
A blinking appears for cooking zones
on which you can presently use the
function.
3. Touch the control bar of any available
cooking zone for which you want to start
the function (between the heat setting
1-14).
The function starts.
If you do not choose any cooking zone within
5 seconds the function does not activate.
Once the function starts the
indicators above the
come on one after another until
the water reaches the boiling
point.
When the function detects the boiling point
the hob emits an acoustic signal and the heat
level automatically changes to 8.
If all cooking zones are already
in use or there is some residual
heat on all of them, the hob
emits a beep sound, the
indicators above
the function does not start.
To deactivate the function touch
function deactivates and the heat setting
goes down to 0) or touch the control bar and
adjust the heat setting manually.
6.10 Timer
• Count Down Timer
You can use this function to set the length of
a single cooking session.
First set the heat setting for the cooking
zone, then set the function.
To set the cooking zone: touch
repeatedly until the indicator of a cooking
zone appears.
/
symbol
blink and
(the