The Heat Setting - Electrolux Y82IS443 Notice D'utilisation

The relation between the heat setting and
the time after which the hob deactivates:
Heat setting
1 - 3
4 - 7
8 - 9
10 - 14

6.3 The heat setting

To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the control
bar until you reach the correct heat setting.
6.4 OptiHeat Control (3 step
Residual heat indicator)
WARNING!
/ /
indicator is on, there is a risk of
burns from residual heat.
The induction cooking zones produce the
heat necessary for the cooking process
directly in the bottom of the cookware. The
glass ceramic is heated by the heat of the
cookware.
The indicators appear when a cooking zone
is hot. They show the level of the residual
heat for the cooking zones you are currently
using:
- continue cooking,
- keep warm,
- residual heat.
The indicator may also appear:
• for the neighbouring cooking zones even
if you are not using them,
The hob deactivates
after
6 h
5 h
4 h
1.5 h
As long as the
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
6.5 Using the cooking zones
Place the cookware in the centre of the
selected zone. Induction cooking zones
adapt to the dimension of the bottom of the
cookware automatically.
You can cook with large cookware placed on
two cooking zones at the same time. The
cookware must cover the centres of both
zones but not go beyond the area marking. If
the cookware is located between the two
centres, Bridge function will not be activated.
6.6 Bridge
The function operates when the
pot covers the centres of the two
zones. For more information on
the correct placement of
cookware refer to "Using the
cooking zones".
The function does not work while
SenseBoil® operates.
This function connects two left side cooking
zones and they operate as one.
ENGLISH 79