METRICA 60801 Mode D'emploi page 3

INSTRUCTIONS
• Slide up the battery compartment cover • Insert 3 AA Alkaline batteries (1.5 V)
• To switch on, slide the switch to ON position: the Green LED (B) of the MODE
button lights.
If the unit is out of self-leveling range, the laser beams will flash• When the in-
strument is powered on, it is ready for indoors operations, with greater visibility
without receiver.
To enable the EXTERNAL operations using the receiver (separately available),
press the DETECTOR button: the green LED (A) lights above it
• To change the laser beams projection, press the MODE button repeatedly:
• 1 time = auto-leveled horizontal line
• 2 times = auto-leveled cross (horizontal + vertical lines)
• 3 times = square (2 vertical lines and 1 horizontal line)
Ref. 60801
––
+
• 4 times = the rays go off, but the device is switched on yet
• Adjust the instrument in the self-leveling range by rotating the feet: the circular
bubble must be inside the circle.
• If the laser beams are fLAShINg, the instrument is outside the SELf-LEvELINg
range. REpOSITION the instrument as indicated above
• To switch the instrument off ROTATE the knob in the Off position: the pendulum
remains locked for transport The red dot on the floor and the cross of the 2 vertical
lines on the ceiling indicate the plumb To make micrometric displacements, rotate
the two screws "v" (photo) at the base of the instrument
• To switch the instrument off permanently MOvE the switch to the Off position
• Feet are rubber coated
TECHNICAL DATA
Working range (depending on brightness)
10 ÷ 15 m
Working range with receiver 50 m
Levelling accuracy ± 2 mm / 10 m
Self-leveling range ± 2,5°
Damping magnetico
Signal of leveling off
si
Laser type 635/650 nm
Output laser classe II
Batteries 3 x 1,5 V AA
Size 180 x 120 x 120 mm
Weight (without batteries)
0,9 Kg
Impermeability IP 54
Tripod thread 5/8"
Importato e Distribuito da: Metrica S.p.A - Via Grandi, 18 - 20097 San Donato Mil.se (MI) - Italy
A
v
B