Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DEFECTS – CAUSES – SOLUTIONS
Defects
Pump does not start
Pump does not stop in
AUTO setting
Pump runs but does
not pump water
Insufficient water
Pump suddenly
switches off while
functioning
If these tips do not provide a solution, contact your supplier or service point.
GUARANTEE
The submersible pump you have purchased comes with the usual guarantee which
applies to production and material defects.
The following damage and defects are not covered by the guarantee:
Wear and tear and defects in relation to mechanical seals caused by drying out or
the presence of specific substances and/or objects in the water.
Causes
No electricity
-
-
Overheating safeguard
activated
The float doesn't activate the
-
pump
Pump is not vertical
-
-
The float is blocked
Inlet openings are clogged
-
Water drainage pipe is bent or
-
hose is blocked
Air around the blade
-
-
Blade is jammed
-
Water level is too low (manual
usage)
Inlet openings are (partially)
-
blocked
Outlet drain (partially) blocked
-
Broken fan
-
Thermal safeguard stops pump
-
due to overheating by f.e. dirty
water
Water is too hot
-
-
Power outage
Dirt or stones in the water
-
supply
Blade is stuck
-
-
Problem with the motor
15
Solutions
Check electrical supply
-
-
See: overheating safeguard.
Put the float at a higher level
-
Make sure the pump is standing up
-
straight
-
Give the float space
Clean them
-
Straighten the hose or remove the
-
blockage
Switch the pump off and move it from
-
side to side. Wait until the air has
escaped and switch on again
Try to remove the blockage or ask a
-
professional to do so
Submerge the pump in deeper water
-
Clean them
-
Remove blockage
-
Replace the fan
-
See: overheating safeguard
-
Max. water temperature 35°C
-
Check fuses and earth leakage
-
Remove dirt and stones
-
-
Remove blockage if possible or
consult service point
-
Consult service point
Publicité
Table des Matières
