Castel XELLIP Serie Mode D'emploi page 23

AUDIO VIDEO IP BLUETOOTH READER DOOR ENTRY STATION
INSTALLATION
Flush mounting of models without numeric keypad
Make a reservation 367mm high, 143mm wide and 65mm deep in the substrate.
Coat the bottom of the recess with at least 10mm of fresh cement.
Insert the base of the doorkeeper into the recess and push it in. Allow the base to protrude 2mm.
Allow the cement to dry for at least 24 hours, then connect the door.
Fix the front panel with the 8 FX (TORX) screws with M3 x 10 studs.
To ensure that your intercom is watertight, it is necessary that the front panel, once mounted, rests on the entire seal
between the bottom and the front panel.
Mounting on plasterboard wall
Create a recess 367mm high, 143mm wide in the wall.
Mount the clamping kit (Option ref. 590.9600) on the entry station base.
Set the entry station base in the recess using the clamps then connect the entry station.
Attach the front panel with the 8 FX teat screws (TORX) M3 x 10.
Technical data sheet no. 604-0403E
= 53 =
= 142,5 =
= 145 =
www.castel.fr
60,5
2 =
=
55 =
53 =
FR
EN
Page 23 / 36