Starting And Stopping The Hedge Trimmer; Rotating Handle; Cutting Tips - Ryobi RY40604 Manuel D'utilisation

STARTING AND STOPPING THE HEDGE
TRIMMER
See Figure 4.
To start:
 Remove the scabbard, if installed.
 Grasp the front handle to release the trigger lock-out.
 Depress the switch trigger to begin operation.
To stop:
 Release the switch trigger to stop the hedge trimmer.
 Release the front handle to re-engage the trigger lock-out.

ROTATING HANDLE

See Figure 5.
The handle can be rotated 45° or 90° to the left or to the right.
To rotate handle:
 Remove the battery pack.
 Press on the rotating handle lever lock.
 Turn handle to the right or to the left.
 Release the rotating handle lever lock.
 Keep turning handle until it locks into place in one of the
45° or 90° positions.
NOTE: The trimmer will only operate at one of these locked
positions. The handle is locked when the rotating handle
lever lock is securely in place and the handle will no longer
move to either side.
HOLDING THE HEDGE TRIMMER
See Figure 6.
The unit has both a front and rear handle. With the blade
directed away from you, hold the unit by both handles.
WARNING:
Always keep both hands on the hedge trimmer handles.
Never hold shrubs with one hand and operate the hedge
trimmer with the other. Improper operation of the hedge
trimmer may result in serious injury.
OPERATION

CUTTING TIPS

See Figure 7.
DANGER:
Never cut near electric cords or lines. If blade jams on
any electrical cord or line, DO NOT TOUCH THE BLADE!
IT CAN BECOME ELECTRICALLY LIVE AND VERY
DANGEROUS. Continue to hold the hedge trimmer by
the insulated rear handle or lay it down and away from
you in a safe manner. Disconnect the electrical service
to the damaged line or cord before attempting to free
the blade from the line or cord. Contact with the blade,
other conductive parts of the hedge trimmer, or live elec-
tric cords or lines will result in death by electrocution or
serious injury.
WARNING:
Clear the area to be cut before each use. Remove all
objects such as cords, lights, wire, or loose string which
can become entangled in the cutting blade and create a
risk of serious personal injury.
 Before starting the hedge trimmer, hold the unit with both
hands with the cutting blades directed away from you.
Always use the hedge trimmer properly.
 Do not force the hedge trimmer through heavy shrubbery.
This can cause the blades to bind and slow down. If the
blades slow down, reduce the pace.
 Do not try to cut stems or twigs that are larger than 1 in.
thick, or those obviously too large to feed into the cutting
blade. Use a non-powered hand saw or pruning saw to
trim large stems.
 If blades do become jammed, stop the motor, allow the
blades to stop and remove the battery pack before at-
tempting to remove the obstruction.
 If desired, you can use a string to help cut your hedge
level. Decide how high you want the hedge. Then, stretch
a piece of string along the hedge at this height. Trim the
hedge just above this guide line of string. Trim the side
of a hedge so that it will be slightly narrower at the top.
More of the hedge will be exposed when shaped this way,
and it will be more uniform.
 Always hold hedge trimmer with both hands when op-
erating. Use a firm grip on the handles. The unit is used
for cutting in either direction in a slow, sweeping action
from side to side.
 Wear gloves when trimming thorny or prickly growth.
 When trimming new growth, use a wide sweeping action,
so that the stems are fed directly into the cutting blade.
Older growth will have thicker stems and will be trimmed
easiest by using a sawing movement.
9 — English