Information On Disposal And Recycling; Technical Data - Videotec UEI Manuel D'instructions

7 Switching on
The illuminator is composed of two groups of LEDs
called SPOT and WIDE.
The operating parameters of the illuminator are set
using the web interface of the PTZ unit.
For the configuration of the web interface, please
refer to the instruction manual relating to the
installed firmware version, available on the product
web page on www.videotec.com.
8 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
MNVKUEI_2222_EN

9 Technical data

9.1 General
Wavelength: 850nm, 940nm (UEIxxx only), white light
UEIxxx
• Wide beam: 40° (horizontal), 16° (vertical)
• Spot beam: 14° (horizontal), 14° (vertical)
UEIxxxP
• Wide beam: 13° (horizontal), 13° (vertical)
• Spot beam: 13° (horizontal), 13° (vertical)
Wide beam activation: based on the scene brightness,
from alarm input or manually
Spot beam activation (can be activated only when
the wide beam is active): can be activated on preset,
based on the zoom factor or with the wide beam
Automatic and remote switching on
No calibration required for light beam alignment with
the camera
The illuminator does not slow down the P&T's
rotation speed
Automatic recognition of the type of illuminator
installed
9.2 Mechanical
Die cast aluminum body
Dimensions (WxHxL): 97x53x54mm (3.8x2x2.1in)
Unit weight: 0.25kg (0.55lb)
9.3 Electrical
Power consumption: 13W
5