Transport, Packaging And Storage; Safety Information For Transportation; Transport Inspection; Packaging - Linde R200 Mode D'emploi

5. TRANSPORT, PACKAGING AND STORAGE

TIPS AND RECOMMENDATIONS!
•
The installation and start- up of this gas supply panel is normally done by the manufacturer or by author-
ized personnel.
•
Even though there can be some users or maintenance personnel who care about the packaging. The fol-
lowing notes should be observed accordingly.

5.1. SAFETY INFORMATION FOR TRANSPORTATION

NOTE!
•
Damages caused by inappropriate transportation!
•
If transported inappropriately, consignments can fall or topple over. This can cause considerable property
damage.
•
When unloading the consignments on delivery and transporting them on the premises, act with caution
and observe the symbols and warnings on the packaging.
•
Use only the attachment points provided.
•
Do not remove the packaging until you are ready to assemble the regulator.

5.2. TRANSPORT INSPECTION

Upon delivery, check immediately that the consignment is complete and has not been damaged during tran-
sit. Procedure on detection of visible transport damage:
•
Refuse acceptance of the delivery or only accept subject to reservation
•
Record the extent of the damage on the transportation documentation or on the forwarder's delivery note
•
File a complaint
TIPS AND RECOMMENDATIONS!
•
Report each and every defect as soon as you discover it. Claims for damages can only be asserted within
the specifi ed periods.

5.3. PACKAGING

The individual consignments are packed according to the anticipated transport conditions. Without exception
all packaging is made of environmentally friendly material.
The packaging is intended to protect the individual components against transport damage, corrosion and
other damage until they are ready for installation. Do not, therefore, destroy the packaging; only remove it
when assembly is imminent.
NOTE!
•
Risk of environmental harm through incorrect disposal!
•
Packaging materials are valuable raw materials. In many cases they can be re-used or recycled. Incorrect
disposal of packaging materials can harm the environment.
•
Dispose of packaging materials in an environmentally compatible manner.
•
Observe locally applicable disposal regulations. If necessary, commission a specialist disposal fi rm.

5.4. STORAGE

Store the packages in the following conditions:
•
Do not store outdoors
•
Store in a dry and dust-free location
•
Do not expose to aggressive media
•
Protect from sunlight radiation
•
Avoid mechanical jolts
•
Storage temperature: 15 to 35 °C
•
Relative humidity: max. 60 %
•
If storing for longer than 3 months, regularly inspect the general condition of all parts and the packaging.
If necessary re-apply or renew the rust-proofi ng
15/298
EN