Cardin Elettronica S504 Serie Mise En Service Et Utilisation page 10

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
REMARKS
These instructions are aimed at professionally qualified "installers of electrical equipment" and must respect the
local standards and regulations in force. The use and installation of these appliances must rigorously respect the
indications supplied by the manufacturer and the safety standards and regulations in force.
This device complies with Part 15 of the FCC rules, and its operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications made to this equipment not expressly
approved by Cardin may void the FCC authorization to operate this equipment. The radiated output power of the
device is far below the FCC radio frequency exposure limits. Nevertheless, the device shall be used in such a manner
that the potential for human contact during normal operation is minimized.
Attention! WEEE marking. This symbol indicates that once the products life-span has expired it must
be disposed of separately from other rubbish. The user is therefore obliged to either take the product to a
suitable differential collection site for electronic and electrical goods or to send it back to the manufacturer
if the intention is to replace it with a new equivalent version of the same product. Suitable differential collec-
tion, environmental friendly treatment and disposal contributes to avoiding negative effects on the ambient and
consequently health as well as favouring the recycling of materials. Illicitly disposing of this product by the owner
is punishable by law and will be dealt with according to the laws and standards of the individual member nation.
Description
The radio control system in "FM" consists of one or more transmitters and one or more receivers which can
be combined to meet the specific needs of the system. The receiver is able to memorise up to 1000 different
codes which are stored via radio in a non-volatile memory module located on the receiver.
Important: The transmitted code changes for each command (rolling code). If disturbance interrupts the
transmission, the receiver will wait for a different code, the relay can then only be activated by first releasing
and then pressing the transmitter channel button again.
Use
The radio control allows the remote activation of electrical and electronic appliances with its best use
in the following areas: automatic opening systems, alarm systems, and in all systems which require
remote control activation (without wires) using secret codes.
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

S508 serie

Table des Matières