CLAS OM 8047 Guide Rapide page 6

OM 8047
DIN/SAE BRAKE LINE REPAIR KIT
Insert the pipe
into the matrix.
Come fl ush with
the inside. Secure
with the needle
screw.
Once the shape
done, unscrew
the "T" and
disassemble the
«S».
Mount the "S" on
the cylinder (or
screw) up to half
thread. Mount
the head adapter
(OP1).
Change the
punch to fi nish
the impression
(OP2).
Screw in the bolt
by hand to block
the approach and
come as close
to the pipe as
possible.
Repeat operation 3
and 4.
Then dismantle.
Then turn via the
T-bar to form the
impression.
If necessary, use
the manual screw
(same principle).