The Display For The Booster; Operation - Marklin Digital 60175 Mode D'emploi

If you want to operate additional 60175 Boosters with the Central Station, then you
can connect the 60125/60145 Terminal to the Central Station and connect up to four
Boosters to each Terminal.

4 The Display for the Booster

Am Booster 60175 ist bei den Anschlussbuchsen eine rote Leuchtdiode (LED), die
verschiedene Zustände des Boosters anzeigt:
LED off
LED on bright
LED on dim

5 Operation

After the Booster has been turned on, it takes a few seconds before the red LED comes
on. The Booster is then ready for operation. While the Booster is in operation, the LED
lights up with different levels of brightness, depending on the situation, and con rms the
correct function.
The 60175 Booster reports different data to the Central Station such as the current con-
sumption and the temperature. The Central Station can display these values at "Setup
Information".
B
0
B 0
The Booster is not receiving current from the switched mode
power pack / transformer.
The Booster has / was switched to STOP.
The Booster is getting no signal from the Central Station.
The Booster is receiving current from the switched mode power
pack / transformer. The track is being powered correctly.
A locomotive decoder is being read via the Booster.
The Booster is working correctly. The brightness of the LED
decreases as the load on the Booster increases.
B
0
booster
9