oneConcept TuneUp ST Mode D'emploi page 29

Saving energy/ Switching on
Dimming
The device has three independent alarms. Two alarms
Alarm
for setting the absolute time (Alarm 1 and Alarm 2) and
one alarm for setting the relative time (NAP).
The factory default alarm source is Internet radio.
Only the same Internet radio station can be selected
for Alarm 1 and Alarm 2. When the set alarm time is
reached, the unit connects to the Internet if the set
network is available. Depending on the availability of
the network, there may therefore be a short delay of
the alarm. If no network connection can be established
within one minute, the alarm tone will automatically
change to "Melody".
The NAP alarm can be set to 5/ 10/ 20/ 20/ 30/ 60/
60/ 90/ 120 minutes. After the set time has elapsed, the
alarm tone you set will sound.
You can use the Sleep Timer to set the time until
Sleep timer
the unit switches off automatically. You can choose
between 15, 30, 60, 90, 120, 150 and 180 minutes. Once
the sleep timer is activated, the corresponding icon
and the remaining minutes are displayed in the real top
corner of the screen. When the time is up, the unit will
automatically go into sleep mode.
You can set both 12-hour and 24-hour format. You can
Date and time
select from the date display YYYY/MM/DD, DD/MM/
YYYYY and MM/DD/YYYYY.
In Internet radio mode, you can directly access the list
Local radio
of local stations. You can set your location manually
settings
or activate automatic location detection. The unit then
determines your location based on the IP address of
your network. Press Local Station to go directly to this
station list.
EN
29