Toro 107-3815 Instructions D'installation

Weight Kit
Power Max
Model No. 107-3815
Use the weight kit when you install the optional snow cab
on a Power Max snowthrower.
Save these instructions with your Operator's Manual for
future reference.
Warning
Operating a Power Max snowthrower with a snow
cab without properly installing a counterweight to
the front of the snowthrower can cause it to tip
backward and fall on the operator, causing injury.
Do not operate a snowthrower that has a snow
cab but does not have the proper
counterweight.
Install this weight kit to the front of the
snowthrower in order to balance the added
weight of the snow cab.
Contents of the Kit
DESCRIPTION
Weight bar
Bolts
Washers
Nuts
Spacers
Installing the Weight Bar on
the Snowthrower
1. Disconnect the wire from the spark plug.
Note: For snowthrowers with a covered 2-cycle
engine, remove the ignition key.
2003—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
Snowthrowers
2. Center the weight bar on the top of the auger housing
(Fig. 1).
3
4
5
QUANTITY
1. Weight bar
2. Auger housing
1
3. Bolt (2)
2
4. Washer (4)
4
3. Mark the locations where you will need to drill
2
2 holes.
2
Note: Mark each hole one inch (2.5 cm) behind the
bend in the auger housing.
4. Drill 2 holes (11/32 inch) in the auger housing at the
locations you marked.
5. Align the holes in the weight bar with the holes in the
auger housing.
Important
bar is visible.
6. Secure the weight bar to the auger housing with
2 bolts, 4 washers, 2 spacers, and 2 nuts provided in
the kit.
7. Connect the wire to the spark plug or insert the
ignition key.
Printed in the USA
All Rights Reserved
Form No. 3350-778
Installation Instructions
1
4
6
2
Figure 1
5. Spacer (2)
6. Nut (2)
7. Bend in the auger housing
Ensure that the danger decal on the weight
Original Instructions (EN)
7