Setting In Operation - Installation; Connection; Installation - Bodet NTP Mode D'emploi

III - SETTING IN OPERATION - INSTALLATION

3.1 Connection

a. Turn the clock upside down on a table.
Unscrew the anti-theft locking screw.
Push the wall holder opposite the two arrows to
unclip it.
Remove the wall holder on the back of the
clock.
b. Connect the Ethernet network on the RJ45
connector.
Ethernet cable category: 4, 5 or 6 (buildings). In
the latter case, use a female wall connector with
a small flexible male/male RJ45 cable.
The type of synchronisation will have to be programmed in the Technician Menu (see page 39),
particularly the Multicast address which must be the same as that of the server (by default
239.192.54.01).

3.2 Installation

Setting of the table bracket (if supplied)
(in the 2 notches of the wall bracket).
26
161
100
Diag.: 2
Reset
Sel.
∞
C
Anti-theft locking
screw