Table des Matières
Publicité
ASSEMBLY INSTRUCTIONS
ALWAYS MAKE SURE THE JUICER IS UNPLUGGED
BEFORE STARTING TO ASSEMBLE.
STEP ONE: Place Juice Bowl
Position the Juice Bowl on top of the Motor Base so
that the Juice Spout is to the right. Lower the Juice
Bowl onto the Motor Base so that the Juice Spout
slides through the oval ring in the Motor Base.
STEP TWO: Place Filter Basket
With both hands, grasp the rim of the Filter Basket
and center it over the Motor Base Hub inside the
Juice Bowl. Carefully lower the Filter Basket onto
the Hub, rotating slightly until it drops into the
proper position; then press firmly down on the rim
of the Filter Basket to secure. (Be sure to apply
pressure the both sides of the Filter Basket evenly
to ensure proper seating.) When seated properly,
the Filter Basket will spin freely and will not lift
out of the Juice Bowl.
CAUTION: Use care when handling the Filter
Basket; the Cutting Blades are very sharp!
STEP THREE: Place Lid
Place the Lid onto the Juice Bowl so that the
Pulp Ejection Opening is positioned over the
Pulp Spout.
STEP FOUR: Attach Feed Tube
Center the Feed Tube over the Lid opening so that
the safety-lock hook on the Feed Tube is is slightly
clockwise from the arrow on the Lid. Insert the
three tabs located around the bottom of the Feed
Tube into the three corresponding slots in the Lid
opening, then rotate the Feed Tube counter-
clockwise until the safety-lock tab on the Feed Tube
aligns with the arrow on the Lid.
11
Publicité
Table des Matières
