Publicité
CONNECTIONS TO YOUR AMPLIFIER
Before making connections, make sure that the amplifier is
switched off.
Black (–)
–
Center speaker
Connections
Connect the screw-type input terminals at the rear of the speaker
to the speaker output terminals of your amplifier with the speaker
cables.
Connect the (+) terminals on both the amplifier and the speaker
using one side of the cable. Connect the (–) terminals on both
components using the other side of the cable.
Connect the speaker to the center terminals of your amplifier,
making sure not to reverse the polarity (+, –). If this speaker is
connected with reversed polarity, the sound will be unnatural and
lack bass.
Procedure:
Loosen the terminal knob.
Remove approx. 10 mm insulation from the speaker cable and
insert the bare wire end properly into the terminal hole.
Tighten the knob.
Test the security of the connections by tugging lightly on the
cable at the terminal.
Note
Do not let the bare speaker wires touch each other as this
could damage the speaker and/or the amplifier.
Loosen
Tighten
Red (+)
+
CENTER
+
–
Amplifier or
Receiver
REMOVING THE FRONT COVER
The front cover is fastened to the enclosure at four points, and can
be removed if desired. To remove the cover, hold on to both sides
and slowly pull straight away from the speaker. To reattach, line up
the four pegs on the inside surface of the cover with the four
corresponding holes on the speaker and push gently.
Note
When the cover is removed, take care not to touch the speaker
units with your hands or to exert excessive force with tools.
SPECIFICATIONS
Type .......................... 2-way 3-speaker bass reflex speaker system
Driver ............................................................ 13 cm cone woofer x 2
Nominal Impedance ............................................................. 6 ohms
Frequency Response ............................................... 57 Hz – 35 kHz
Nominal Input Power .............................................................. 100 W
Maximum Input Power ........................................................... 300 W
Sensitivity ................................................................ 90 dB/2.83 V/m
Crossover Frequency .............................................................. 3 kHz
Dimensions (W x H x D) ................................... 500 x 168 x 201 mm
Weight ....................................................................................... 7 kg
Accessory ......................................................... Velcro strips (4 sets)
Specifications subject to change without notice due to product
improvements.
Care should be taken not to exceed the input power values
noted above.
(Magnetically-shielded type)
3 cm dome tweeter
V556620
Publicité
