Yamaha NX-N500 Mode D'emploi page 17

■ Using the WPS push button
configuration
You can easily set up a wireless connection with one push of
the WPS button.
1
Set the WIRELESS switch on the rear panel to
"AUTO".
Left speaker (rear panel)
AC IN
GAIN
MIN MAX
• If a wired connection has already been established with this unit, the
WIRELESS switch on the unit must first be set to "OFF" while the unit is
on. After disconnecting the network cable, set the WIRELESS switch to
"AUTO".
2
Press z (power) on the remote control to turn
on the unit.
The status indicator on the front panel flashes in green.
Left speaker (front panel)
• If no network connection has been set up when the main power is
turned on, the indicator lights up in pink, and the unit automatically
searches for an iOS device (iPhone or iPod touch). For details on network
connections with iOS devices, see "Sharing the iOS device setting" (p.15).
16
En
R CH
AUDIO OUT
AUTO
WIRELESS switch
WIRELESS
OFF
CONNECT
WIRELESS
DIRECT
SOURCE
Green (flashing)
3
Hold down WPS on the remote control for 3
seconds.
The status indicator on the front panel flashes in green.
• If the input source is changed or this unit enters standby mode, the
setup operation is canceled.
4
Press the WPS button on the wireless router
(access point).
The WPS button on the wireless router (access point)
must be pressed within 2 minutes after completing step
3. After 2 minutes have passed, the setup operation is
canceled.
When the connection is established, the status indicator
on the front panel lights up in green.
Left speaker (front panel)
About WPS
WPS (Wi-Fi Protected Setup) is a standard established by the Wi-Fi
Alliance, which allows easy establishment of a wireless home network.
WPS
Green (lit)