Table des Matières
Publicité
PROBLEM SOLVING
This appliance was inspected thoroughly and was in good operating condition when it
was shipped from the factory. If a minor problem occurs, it usually can be solved quite
easily when the cause is found. Therefore, this checklist is provided for your
convenience.
PROBLEM
POSSIBLE CAUSE
1. Not properly plugged into
wall outlet.
2. No electricity in wall outlet.
Cleaner Won't
3. On/Off switch not turned
Run
on.
4. Motor thermostat tripped.
5. Blown fuse/tripped
breaker.
1.
Full or clogged dust cup.
2.
Wrong pile height setting.
3.
Clogged nozzle.
4.
Clogged dust inlet port.
5.
Clogged hose.
Cleaner Won't
6.
Broken belt.
Pick Up
7.
Hose not inserted fully.
8.
Dirty filters.
9.
HEPA filter needs
cleaning or replacing.
10. HEPA filter frame needs
cleaning
Cleaner Picks
Up Moveable
Rugs Or
1.
Wrong pile height setting.
Pushes Too
Hard
Agitator Does
1.
Broken belt.
Not Turn
2.
Belt installed incorrectly.
Air Driven
1.
Rotating brush, turbine or
Turbo Brush
elbow obstructed.
Does Not
2.
Belt broken.
Rotate Or
3.
Hose obstructed.
Rotates
4.
HEPA filter clogged.
Slowly
Air Flow
Restricted
1.
Attachment use restricts
With
air flow.
Attachment
2.
New carpet debris
clogging air path.
Use Sound
Changes
POSSIBLE
1.
Plug in firmly.
2.
Check fuse or breaker.
3.
Push on/off switch to on
4.
Reset motor thermostat.
5.
Reset circuit breaker or replace
fuse.
1.
Clean dust cup.
2.
Adjust setting.
3.
Remove obstruction.
4.
Remove power head cover and
remove obstruction.
5.
Remove obstruction.
6.
Replace belt.
7.
Push hose in securely.
8.
Clean / change filters.
9.
Clean or replace HEPA filter.
10. Clean HEPA filter frame.
1.
Adjust setting.
1.
Replace belt.
2.
Check belt changing and agitator
cleaning.
1.
Clear obstructions.
2.
Call 1-800-798-7398.
3.
Clear obstruction.
4.
Clean HEPA filter.
1.
Check attachment.
2.
Remove obstruction.
10
FAMILIARISEZ-VOUS AVEC ASPIRATEUR VERTICAL
CYCLONIQUE SANS SAC
19
1. Poignée supérieure
2. Bouton d'alimentation On/Off
3. Levier de relâche de la coupelle
4. Coupelle à poussière
5. Cadre du filtre HEPA
6. Sélecteur de hauteur de tapis
7. Garde-meuble
8. Lampe
9. Électrobrosse motorisée
Spécifications techniques
Tension :
120 V, 60 Hz
Intensité :
12 A
Remarque : Les illustrations peuvent différer de l'appareil lui-même.
10. Boyau souple
11. Cordon d'alimentation
12. Porte-cordon à relâche rapide
13. Brosse ronde
14. Brosse à meubles
15. Suceur plat
16. Boyaux de rallonge (x2)
17. Raccord de tuyau
18. Sélecteur tapis-plancher
19. Brosse turbo actionnée à l'air
27
Publicité
Table des Matières
