Important; Preparation - MAUNAWAI KINI Instructions De Montage Et D'utilisation

PREPARATION

Before you begin assembly, please ensure that you
carry out the following preparatory steps:
1 Remove all packaging from the system and from
both filters.
All reservoir parts clean with
a mild (eco-friendly) detergent
and rinse thoroughly with
clean water.
Filter modules: Limescale filter pad and PI filter cartridge
2
Place all filter modules
1
Clean all the reservoirs and other parts of the
under water overnight.
system – but not the two filters – with an eco-friend-
ly detergent and rinse them thoroughly with clean
water.
Note:
Never use soap or cleaning materials for the
MAUNAWAI® Jug, the PI filter cartridge and the li-
3
mescale filter pad.
Avoid boiling water when cleaning or using the ca-
Afterwards shake
vigorously several times.
tridges.
Only use soft cleaning cloths to avoid scratches on
the plastic parts.
2

Important:

Soak the limescale filter pad and the PI filter car-
Only use drinking tridge overnight. Never use a dry limescale filter pad.
water or tap water
that is suitable and
3
approved for human Afterwards shake the PI filter cartridge vigo-
consumption. rously several times.
14
ASSEMBLY
After these preparations it is very simple to assem-
ble your MAUNAWAI® Jug as follows:
1
Push the PI filter cartridge firmly into the filling
reservoir (the inner reservoir of the jug).
2
Place the soaked limescale filter pad (see prepa-
ration) into the top of the PI filter cartridge. Click the
lid onto the filter cartridge to keep the limescale filter
pad in place.
Note: Never insert a dry (i.e. firm) limescale filter pad
into the cartridge.
Make sure that the PI filter cartridge is upright and
fits firmly into the reservoir. You may need to apply
some pressure to get the filter to sit properly in the
reservoir.
Where possible, only touch the filter and especially
the limescale filter pad with clean hands or house-
hold gloves, to ensure the best possible level of hy-
giene.
3
Place the filling reservoir into the storage reser-
voir and then place the Lid firmly onto the jug. Use
gentle pressure until the parts ‚click' into place.
Filter some 4–5 litres of water until the water is com-
pletely clear, without any cloudiness. Do not drink the
first five litres; use them for something else, such as
watering your plants.
Now your MAUNAWAI® Jug is ready to use.
1
From above, push the PI-
filter cartridge firmly into the
storage reservoir.
2
Insert the prefilter at the top
of the PI filter cartridge.
en
3
Place the different parts
of the Jug into each other,
end up with the lid on top.
Use gentle pressure until
the parts ‚click' into place.
Ready!
15