Fcc Statement - Skil ME9821-00 Guide D'utilisation

Laser jusqu'à 20 m, 65 pi avec molette
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Do not operate this tool outdoors.
Do not place or store this tool under extreme temperature
conditions.

FCC STATEMENT

The manufacturer is not responsible for radio interference caused
by unauthorized modifications to this equipment. Such modifications
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
NOTE! This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
4

Publicité

Table des Matières
loading

Table des Matières