Setup - ABB M2233 Serie Mode D'emploi

ABB-Welcome M

4.2.12.14 Setup

1
2
3
Fig. 33 Setup
The "Set-up"menu has the following functions:
No. Function
1 Automatic Snapshots
- When the bell is pressed, three snapshots are automatically taken and
stored in the History.
- This function can only be activated when the autom atic door opener is
deactivated. Otherwise, too many snapshots would be stored during
busy periods.
2 Door status Check
- Tick the checkbox you activate or deactivate the door status check. If
activating the function, the outdoor station with a sensor installed will
send alarm signal to indoor station when the door is open over time.
3 Key Illumination
- Tick the checkbox to activate or deactivate the key illumination. If
activating the function, the key will be illuminated during operation. Or
else, the key illumination will be off all the time.
4 Indoor Station Address
- This option is enabled only when the last two rotary switches of IS are
set as "00", and it can be set from 001 to 250.
5 OK
- By tipping on this button you activate the settings.
|
Operation
4
6
5
— 49 —