Sera PRECISION feed A plus Mode D'emploi page 5

US Information for use
Inserting the battery:
• Remove food container
chamber , insert battery (size AA) in correct
2
polarity , close chamber. The unit is ready
3
to use.
• The turning shaft within the timer
cates whether the battery is still alright.
Filling in food:
• Pull off the lid
5
case the dosage adjuster
simply put it back in place. Fill in food
• Push the cover onto the food container
shaft, the "UP" arrow directing upwards
until the cover snaps in.
• Push the food container onto the rotating
shaft of the timer
between MIN and MAX
• Adjust the food amount with the dosage
adjuster .
10
Setting the timer:
• Take off the splash water protection
set the timer to the current time by turning
the adjustment knob
must direct towards the start knob above the
timer 13 .
• Push the red pins into the timer according to
the desired feeding times
gered by the pin at the adjusted time. The kit
contains 6 pins.
• You can trigger additional feedings anytime
by turning the start knob
the arrow.
Notes:
1. The food container
and clean before filling in new food.
2. Use only dry food of normal size. We recom-
mend sera vipan and sera vipagran. You can
prevent the food from clogging by connect-
ing, for instance, a sera air 110
15
connector .
3. Avoid places with high temperature. Do not
shake the product strongly as to retain its reli-
ability. Temperature range: up to +50°C (122°F).
Spare parts:
sera pins (30 pcs., item no. 08842)
sera food container (item no. 08844)
1 , open battery
from the food container. In
10 becomes loose,
8 . The food level should be
.
9
. The current time
12
. Feeding is trig-
14
as indicated by
13
must be absolutely dry
1
to the air
16
Important: Please take care for a professional
disposal of the batteries according to legal pre-
scriptions.
Disposal advice: Please dispose only emptied
batteries into the collection containers at the
store or the community. Batteries are empty if
"LowBat" is displayed or the unit switches off.
4 indi-
Disposal of the unit:
Waste electrical and electronic equipment
(WEEE) must not get into domestic waste!
If ever the unit cannot be used anymore, the
consumer is legally obliged to hand in waste
6 . electrical and electronic equipment (WEEE)
separately from domestic waste, e.g. at a col-
lection point of his community/his district. This
7
ensures that waste electrical and electronic
equipment (WEEE) is expertly processed and
that negative effects to the environment are
avoided.
Therefore electrical and electronic
equipment bears the following symbol:
and Warranty:
11
When following the directions for use the sera
feed A plus automatic feeder will perform reli-
ably. We are liable for the freedom from faults
of our products only within legal regulations
beginning with the purchase date.
We are liable for complete flawlessness at deliv-
ery. Should usual wear and tear occur by use as
intended by us, this is not considered a defect.
Warranty claims are also excluded in this case.
This particularly refers to the batteries.
In every case of a defect we recommend that
you consult the specialized retailer where you
purchased the unit. He will be able to judge
whether it is actually a warranty case. In case of
sending the unit to us we will unnecessarily
have to charge you for occurring costs.
Any liability because of contract breach is limited
to intent or gross negligence. sera will be liable
in case of slight negligence only in case of
injuries to life, body and health, in case of
essential contractual obligations and with bind-
ing liability according to the product liability
code. In that case, the extent of liability is limit-
ed to the replacement of contractually typically
foreseeable damages.
5