Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4
Trim Installation
A.
1
Trim Sleeve Installation
Slide trim sleeve (1) over the bonnet (2) and
O-ring. Ensure sleeve is properly positioned
over the front of cartridge with set screw access
hole downward. O-ring will help keep trim sleeve
securely in position.
C.
9
11
13
10
Valve Handle Installation
Slide handle (9) over cartridge, aligning flat
surfaces inside handle with flat surfaces on
side of cartridge (14). Handle lever should point
downward (6 o'clock) in the off position. Secure
handle with screw (10). Ensure that O-ring (11) is
assembled on handle cap (13). Install handle cap
(13) by pressing it into place on top of the handle
(9). Secure cap by tightening screw (12) from the
underside of the handle.
106512 Rev. A
2
14
12
6
B.
19
7
8
18
Escutcheon Installation
Secure backplate (3) to rough-in body (4) using 4
screws (5) provided. Ensure backplate is oriented
front side forward.
Note: Be sure backplate is oriented front side
forward and markings are visible.
If mounting to an uneven surface, apply appropriate
sealant around the backplate to supplement rubber
seal. Align holes in escutcheon (6) onto backplate.
Slide sleeve (19) onto escutcheon (6) and secure
by threading trim nut (7) onto diverter sleeve. Do not
over-tighten. Ensure that O-ring (18) is assembled to
trim nut (7). Slide diverter base (8) over trim nut (7).
For thick wall installation, an optional extension
kit is available to accommodate up to 1" of
additional wall thickness. Order RP100670.
D.
15
14
16
17
Diverter Handle Installation
Slide diverter handle (14) onto diverter sleeve (15).
Using an allen wrench, insert set screw (16) into
handle (14). Applying pressure, insert set screw
cover (17) until properly seated.
4
3
5
5
6
Publicité
Table des Matières
