Trim Installation - Brizo MultiChoice T75P Serie Instructions D'installation

Trim Installation

4
A.
1
Trim Sleeve Installation
Slide trim sleeve (1) over cartridge, bonnet (2),
and O-ring. Ensure sleeve is properly positioned
over the cartridge. O-ring will help keep trim
sleeve securely in position.
C.
9
Valve Handle Installation
Slide handle (9) over cartridge, aligning flat
surfaces inside handle with flat surfaces on
side of cartridge. Handle lever should point
downward (6 o'clock) in the off position. Secure
handle with set screw (10) and press button (11)
cover into hole.
2
10
11
T75P Series Installation
B.
5
6
7
8
Escutcheon Installation
Secure backplate (2) to rough-in body (3) using 4
screws (4) provided. Ensure backplate is oriented
front side forward. Note: Be sure backplate is
oriented front side forward and markings are
visible. If mounting to an uneven surface, apply
appropriate sealant around the backplate to
supplement rubber seal. Align holes in escutcheon
(5) with cartridges and slide escutcheon (5) onto
backplate. Secure escutcheon by threading trim
nut (6) onto diverter sleeve. Do not overtighten.
Slide diverter trim sleeve (7) over trim nut and
secure into position with set screw (8). For
thick wall installation, an optional extension
kit is available to accommodate up to 1" of
additional wall thickness. Order RP91024 &
RP92548.
D.
1
3
4
Diverter Handle Installation
Insert diverter handle (1) onto trim sleeve (2).
Using a allen wrench, insert set screw (3) into
handle (1). Applying pressure, insert set screw
cover (4) until properly seated.
7
4
2
2
92658 Rev. B
3