All manuals and user guides at all-guides.com
Setting of measuring mode and measurement unit
Pressing the operating button with the appliance switched on but not in contact
■
with the substrate displayed the possible measurement modes and
The currently selected measurement mode is indicated on the display.
3
Pressing the operating button again switches to the next measurement mode.
■
This is activated if the button is not pressed again for approx. 2 seconds.
3
UNIT
If
is marked, a menu with
■
measurement is marked.
Pressing the button again allows you to switch to the other unit of measure-
■
ment.
Measurements with the dual probe
The appliance offers various possibilities for selecting the measurement mode. The
measurement mode can be selected by pressing the operating button with the
appliance switched on as described above.
Fe or NFe mode
For applications where the substrate is clearly defined, the Fe or NFe mode
■
can be set as the standard measurement mode.
The measurement mode currently being used is indicated along the left edge
3
of the display.
Fe/NFe mode
For continuous changes between steel and non-ferrous substrates, Fe/NFE
■
mode can be activated.
The mode is indicated on the display by a symbol with two round arrows.
3
The appliance is in semi-automatic mode.
3
At a change of substrate, a message is display signalling the change and
3
prompting the user to measure again by raising the appliance and then
placing on the substrate again.
With the NFe measurement method it is possible to carry out a
measurement on a ferromagnetic substrate (e.g. iron, steel).
16
μm
mil
and
is opened in which the set unit of
UNIT
.