Mopar 82216335AA Mode D'emploi page 3

STANDARD BED INSTALL
3.0 COVER LATCHING at the
REAR/TAILGATE END.
Close the tailgate and unfold
3.1
the cover. Check that the
cover is parallel and square
with the truck bed and bed rails.
If not parallel or square,
open the cover and loosen the
cab clamps to reposition
the cover.
NOTE: When opening the cover,
be sure to stow the tail clamps
into the cover bow to prevent
damage to the tarp when folded.
Open the tailgate, swing the
3.2
tail clamps (2) down from the
stowed position and slide them
toward the truck bed rail.
Swing the clamps and pull
down so the clamp jaw is
under the truck bed rail.
2
4.0 INSTALLATION COMPLETION Installer to fold this I-Sheet and place it in the vehicle's glove box.
November 27, 2019
www.mopar.com
The clamp jaw must be in contact with the metal
truck bed rail. Do Not secure to the plastic bed rail
or bed cap. Check that both clamps are securely
tightened to the metal bed rail.
3
K6864060AA