Cardin Elettronica SSB Serie Mode D'emploi page 20

5. Activating transmission using a user code
5a Type the user code into the keyboard
and press confirm "
5b The keyboard sounds a 2-second long beep and the green LED lights up.
The code has been accepted!
5c Press A-B-C or D in the right-hand column of the keyboard (e.g. "C")
5d The keyboard will sound a beep and during transmission the green LED will flash
5e After 5 seconds of inactivity the keyboard will sound a beep.
The green LED switches off and the keyboard quits the mode.
If only one function has been assigned to the code (e.g. A), once it has been confirmed by pressing
*
" ", the relative function will be activated automatically (A).
6. Memorising the keyboard in a standard receiver or in an electronic programmer
To memorise the keyboard in a receiver at least one user code must have been memorised (along with the
functions you wish to activate).
With the receiver in the vicinity carry out one of the following 2 procedures:
*
"
20
9
D
4
8
*
#
7
0
*
ON
A
3
A
3
B
2
6
1 C
5
9
D
4
8
ON
A
3