Inserting And Replacing The Batteries - Cardin Elettronica SSB Serie Mode D'emploi

5) Press the channel to memorised on the keyboard:
the green LED will flash on the keyboard.
After memorising the receiver will sound a half second beep, after which the receiver
will be ready to memorise another channel.
6) To leave the programming mode let 3 seconds pass without memorising any more
codes. The receiver will sound a 5-second long beep and exit the programming
mode.

7. Inserting and replacing the batteries

6V power supply with a KITSSB-T9K4-1 battery pack (2xCR2032) and con-
nector.
• Connect the batteries to the power wires "A".
• Insert the batteries into the circular seat "B" on the
bottom of the keyboard making sure that the wires
are free.
• Check the connection by pressing any key: the green
LED should light up and the keyboard will sound one
beep.
Note:Thebatterychargelevelcanbecheckedbypressing
any key in the function mode:
- The green LED lights up: battery charged
- The green LED and red LED light up: flat battery
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
23
ON
A
3
B
A
4