Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USED AS AN EMERGENCY
JUMP STARTER
E
N
NOTE: For maximum power, do not
G
store below 50° when using
L
as a jump starter.
I
WARNING
S
H
RISK OF INJURY FROM
MOVING PARTS.
•
NEVER connect the TRUCK PAC
clamps to a vehicle when the engine
is running.
•
ALWAYS stay clear of fan blades,
fan belts, pulleys and other moving
engine parts when working near an
engine. Moving engine parts can
cause severe personal injury
including dismemberment.
•
ALWAYS make sure that the TRUCK
TM
PAC
cables and clamps are
positioned so they will not come in
contact with any moving engine
parts.
1. Turn ignition off before making cable
connections.
2. Do not touch RED (POS +) clamp to
BLACK (NEG –) clamp.
3. Use in well ventilated area.
4. Shield eyes.
5. With the selector switch in the OFF
position, clamp the positive (red, +)
clamp to the positive terminal on the
weak battery (for negative ground
system).
6. Clamp the negative (black, –) clamp
to the engine (ground). Make sure
cables are not in the path of moving
belts or fan. Do not connect to the
negative clamp to any fuel lines.
7. Set the selector switch (2 in Figure
1) to the vehicle voltage (12 VOLT
SYSTEMS or 24 VOLT SYSTEMS)
8. Stay clear of batteries while jump
starting.
9. Allow the TRUCK PAC
the vehicle's battery for 5–15
minutes.
6
10. Start the vehicle.
11. Once the vehicle is started, set the
12. Disconnect the negative (black
TM
13. Disconnect the positive (red cable)
14. Return the clamps to their holsters
USED AS AN ALTERNATIVE
POWER SUPPLY FOR
VEHICLES
(FOR 12 VOLT SYSTEMS ONLY)
The TRUCK PAC
tool for all who replace vehicle batteries.
Most vehicles have some type of
electronic component with memory, such
as alarm systems, computers, radios,
phones, etc. and when the vehicle's
battery is replaced, memory is lost.
However, if the power charging cord is
plugged from the TRUCK PAC
cigar lighter outlet on the vehicle, the
memory can be saved.
MULTI PURPOSE POWER
SUPPLY
The TRUCK PAC
power source for most 12 Volt
accessories with a male cigar lighter plug.
When used with an inverter, it can
operate appliances normally powered by
120 Vac (or 240 Vac in Europe).
TM
to charge
Note:
If the vehicle doesn't start
within 6 seconds, let the
TRUCK PAC
battery cool for three (3)
minutes before attempting to
start the vehicle again or
damage to the unit may occur.
selector switch OFF.
cable) clamp from vehicle ground
(the engine).
clamp from the positive (POS, +)
battery terminal.
for storage.
TM
is an ESSENTIAL
TM
is also a portable
Note:
Use of an inverter using 240
watts or more requires the
connection to be made
through the clamps instead of
the 12 Vdc power receptacle.
TM
's internal
TM
to the
Publicité
Table des Matières
