TRUCK PAC ES-1224 Manuel De L'utilisateur page 4

• NEVER smoke or allow a spark or
flame in vicinity of battery or engine.
E
• Be extra cautious to reduce risk of
N
dropping a metal tool onto battery. It
G
might spark or short circuit battery or
L
other electrical part that may cause
I
S explosion.
H
• Remove personal metal items such
as rings, bracelets, necklaces and
watches when working with a lead-
acid battery. A lead-acid battery can
produce a short-circuit current high
enough to weld a ring or the like to
metal causing a severe burn.
• Use the TRUCK PAC
or boosting LEAD-ACID batteries
only. Do not use for charging dry-
cell batteries that are commonly used
with home appliances. These
batteries may burst and cause injury
to persons and damage to property.
• NEVER charge or boost a frozen
battery.
• NEVER allow clamps to touch
together or to contact the same piece
of metal to prevent arcing.
• Use of an attachment not
recommended or sold by the
manufacturer, may result in a risk of
damage to the unit, or injury to
personnel.
• When using the wall charger or
power extension cord, pull on the
plug and NEVER ON THE WIRE
when disconnecting.
• Do not recharge the TRUCK PAC
with a damaged wall charger or
power extension cord. Replace them
immediately.
• The TRUCK PAC
under any weather condition. Rain,
snow, hot, or cold temperatures.
However, recharging the unit should
be done indoors.
4
TM
for charging
TM
TM may be used
• Do not submerge in water.
• Do not operate with flammables such
as gasoline etc.
• If the TRUCK PAC
sharp blow or is otherwise damaged,
in any way, have it checked by a
qualified service person. If the
TRUCK PAC TM
acid do not ship it. Take it to the
closest battery recycler in your area.
• Do not disassemble the TRUCK PAC
TM . Have it checked by a qualified
service person.
• The TRUCK PAC
left in a total discharged state for any
period of time. Damage to the battery
could be permanent with poor
performance as a result. When not
in use, leave the TRUCK PAC
connected to the wall charger or
recharge every three (3) months.
OPERATING
INSTRUCTIONS
CHARGING YOUR NEW
TM
TRUCK PAC
TM
Your TRUCK PAC
the factory. It is best for the battery in the
TM
TRUCK PAC to be kept at full charge.
We recommend that you should plug in
the TRUCK PAC TM
immediately after purchase until it is
required for use. The charging circuit is
automatic, and will not overcharge when
using the wall charger. When all the
power level lights and the charged light
come on while charging or when the test
button is pressed, your unit is fully
charged. (See Figure 2.)
Figure 2. Test Button & Charge
Lights
TM
receives a
is leaking battery
TM
should never be
TM
was precharged at
to the wall outlet