Install The Hood - Glem GHP945IX Mode D'emploi

will reduce the performance of the hood. Use as few of them as possible.
Larger ducting may be required for best performance with longer duct
runs.
4. The air must not be discharge into a flue that is used for exhausting
fumes from appliances burning gas or other fuels" "Regulations
concerning the discharge of air have to be fulfilled.
5. Install wall cap. Connect round metal ductwork to cap and work back
towards hood location. Use duct tape to seal the joints between
ductwork sections.
INSTALL ELECTRICAL
Electrical wiring must be done by a qualified person(s) in accordance with all
applicable codes and standards. This range hood must be properly grounded.
Turn off electrical power at service entrance before wiring.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard

INSTALL THE HOOD

Note 1 : On stainless steel hoods, carefully remove the plastic protective film
from all exterior surfaces of the hood and chimney prior to final installation.
Note 2: At least two people will be required to mount the hood.
INSTALL THE HOOD
Minimum hood distance above the cooker
must not be less than 650mm.
A maximum of 750mm above the cooker is
highly recommended for best capture of
cooking impurities.
Distance over 750mm above the cooker are at
the installer's and user's discretion - providing
that ceiling height and flue length permit.
1. Secure the hood mounting bracket to the
wall using (3) ST 5 x 45mm mounting
7
.