Replacement Of Hoes; After Use; Guarantee - R2 MT Manuel D'emploi Et D'entretien

Replacement of hoes

The hoes must be replaced by resting the machine on its side so that the hoes
are parallel to the ground.
When assembling new hoes, make sure that the fixing nut is properly inserted
in its slot. We also recommend to replace the entire set of nuts and bolts each
time the screws are worn (NOTE: always use the original, fine-pitch steel nuts
and bolts).
To take maximum advantage of the hoes, the machine has two extensions (Fig. 7 -
Ref. A) on the sides making it possible to work even with worn hoes; they must not
be worn for over 2/3 of the hoe length.
NOTE: For small-displacement cultivators (8-10 HP), make sure that the power take-
off is at least 28-30 cm off the ground. If the height is instead apporximately 25-26
cm, it is recommended to shorten the hoe in order to align the machine with the cul-
tivator.

After use

If the MILL GRADER Mod. MT e MTL is to remain unused for a long period, it is necessary to carry out the
following instructions:
1. Thoroughly wash and dry the MILL GRADER Mod. MT e MTL.
2. Thoroughly check the working of the moving parts, replacing any damaged, worn or deteriorated
parts.
3. Check the tightening of the bolts.
4. Check the lubricant level in the reduction casing.
5. Protect and lubricate all unpainted parts, cover the tool and keep it in a dry place so that it will be ready
for use at any time.
Attention: before using it again, refer to the "Maintenance" chapter.

Guarantee

our equipment is coveres by guarantee against manufacturing and/or assembly defects for 1 year from the date
of delivery to the customer.
This guarantee in limites to the replacement of defective parts and does not include costs or transport.
This guarantee does not cover the following cases:
- Where the user has made adaptations to the original structure.
- Where the machine has been used in excess of its power limits.
- Where R2 spare parts are not used.
- Where the equipment is not used in accordance with the instructions in the manual.
- Where the equipment has been used incorrectly.
The R2 Company reserves the right to modify the data in this manual whenever this is considered necessary for
technical or commercial improvements regardind the product itself.
A
g.7
11