Technical Specifications; Preparation Before Use; Coupling To The Engine-Driven Cultivator - R2 MT Manuel D'emploi Et D'entretien

C
Technical specification
The MILL GRADER Mod. MT e MTL is built in the MTL 50 - 75 - 100 e MT 60 - 90
.................................................................
Milling length.................................. 50 cm
Levelling length............................... 50 cm
Compressing length ........................ 60 cm
Min. power required........................ 10 HP
Max. working depth......................... 14 cm
Nr. of hoes .................................... 6
Weight.......................................... 70 Kg

Preparation before use

Before starting operation it is necessary to perform following steps:
- Check that the machine is in perfect working order.
- Check that lubricant is at the correct indicated level.
- Check the tightness of the bolts and that all parts are in perfect order.
Coupling to engine-driven cultivator
Before applying the machine flange (Fig. 2 – Rif. A), corresponding to the type of engine-driven cultivator you have,
it is recommended to spread grease on the outer diameter of the machine hub (Fig. 2 – Rif. B) to lubricate machine
oscillation. Then insert the flange with its two special screws (dowels) (Fig. 2 – Rif. C) and two nuts. To attach the
flange to the hub, proceed as follows:
- Screw the two dowels in, as far as they will go; when they have stuck the bottom, unscrew them by one
turn. Move the nuts in and tighten. After this operation, make sure that the flange oscillates freely without
squeezing or blocking; if necessary, repeat the operation.
- Then insert the trasmission sleeve (Fig. 2 – Rif. D) on the machine shaft, after first greasing it.
A
C
A
MTL50 MTL75
75 cm
75 cm
85 cm
14 HP
14 cm
10
95 Kg
B
g.1
D
C
MTL100 MT60
100 60
100 60
110 cm 70 cm
14 HP 10 HP
14 cm 14 cm
14 6
115 Kg 90 Kg
B
g.2
MT90
90
90
100 cm
14 HP
14 cm
10
110 Kg
9