Braun BGK 7050 Mode D'emploi page 14

sensation of epilation, you may replace the massage cap (1a) with the efficiency cap
(1b) which provides a closer skin contact and an improved adaptation to all body areas.
Leg epilation
Epilate your legs from the lower leg in an upward direction. When epilating behind the
knee, keep the leg stretched out straight.
Sensitive area (e.g. underarm) epilation
• The sensitive cap (8) has been specifically designed for this use. Place it onto the
epilation head. Please be aware that especially at the beginning, these areas are
particularly pain-sensitive. Therefore, we recommend that you select speed setting
«I» for the first few times. With repeated usage the pain sensation will diminish.
• Before epilating, thoroughly clean the respective area to remove residues like
deodorant.
• When epilating the underarm, keep your arm raised up so that the skin is stretched
and guide the appliance in different directions. As skin may be more sensitive directly
after epilation, avoid using irritating substances such as deodorants with alcohol.
Cleaning the epilation head
Regular cleaning ensures better performance.
Brush cleaning (5a):
Remove the cap and brush it out. Thoroughly clean the epilator head from the rear side
with the brush dipped into alcohol. While doing so, turn the tweezer element manually.
This cleaning method ensures best hygienic conditions for the epilation head.
Cleaning under running water (5b):
After each wet usage, clean the appliance under running water. Remove the cap. Hold
the appliance with the epilation head under hot running water. Then press the release
button (6) to remove the epilation head. Thoroughly shake both, the epilation head and
the appliance to make sure that remaining water can drip out. Leave both parts to dry.
Before reattaching, make sure that they are completely dry.
Usage of the shaver head (B)
The shaver head (9) is designed for a fast and close shave of legs, chest and
underarms, trimming and cutting hair. With the shaver head attached, use the appliance
only on dry skin and with speed setting «II».
Shaving (a): select « ».
Trimming (b): select « ».
Cutting to 5mm length (c): select « » and put on the trimmer cap (I).
Cleaning (d): Remove the shaver head and tap it out. Do not clean the shaver foil (II)
with the brush as this may damage the foil.
Lubrication (e): The shaving parts need to be lubricated regularly every 3 months.
Replacement of shaving parts (f): Replace the foil frame (II) and cutter block (III)
when you notice a reduced shaving performance. Replacements parts can be obtained
from your retailer or Braun Customer Service Centres or via www.service.braun.com.
14