Assembly - Husqvarna PS-EX1100 Manuel D'utilisation

and chain drive sprocket. Refer to
chain on page 12 .
• Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
To assemble the cutting head
CAUTION: Make sure that the drive shaft
inside the shaft engages with the cut-out in
the cutting head.
B
1. Loosen the screw on the cutting head. (A)
2. Fit the cutting head on the shaft so that the screw (A)
is aligned with the hole in the shaft as shown.
3. Screw in screw A finger tight. Make sure that screw
A fits into the hole in the shaft.
4. Tighten screw A.
5. Tighten screw B.
To assemble the bar and chain
1. Unscrew the bar nut and remove the protective
cover.
2. Fit the bar over the bar bolt. Place the bar in its
rearmost position. Place the chain over the drive
sprocket and in the groove on the bar. Begin on the
top side of the bar.
3. Make sure that the edges of the cutting links are
facing forward on the top edge of the guide bar.
6
To tension the

Assembly

4. Fit the cover and locate the chain adjuster pin (A) in
A
5. Tension the chain by turning the chain tensioning
6. The chain is correctly tensioned when it does not
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
the hole in the bar. Check that the drive links of the
chain fit correctly on the drive sprocket (B) and that
the chain is in the groove in the bar (C). Tighten the
bar nut finger-tight.
A
screw clockwise using the combination spanner. The
chain should be tensioned until it does not sag from
the underside of the bar.
sag from the underside of the bar, but can still be
turned easily by hand. Hold up the bar tip and tighten
the bar nuts with the combination spanner.
B
443 - 007 - 13.01.2020