Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
W-MBus Modems/Receiver/Repeater- Guide utilisateur / User guide version V1.8.2
8. Wireless M-Bus Repeater AMR
The Wireless M-Bus repeater AMR (Automatic Meter Reading) from adeunis® is a ready-tu-use system allowing to repeat radio frames from
Wireless MBus transmitters.
This repeater can double the range of Wireless M-Bus transmitters AMR and thus ensure a seamless transmission of radio frames in harsh envi-
ronments or when the data concentrator is distant.
By combining several Wireless M-Bus repeaters AMR, adeunis® extends the transport of transmitted frames over several kilometers.
The repeater is available in two versions :
•
Main power supply : T1 mode (S1 or R1 on demand)
•
Battery power supply : T1
8.1. Technical specifications
8.1.1 Products
Name
Wireless M-Bus repeater AMR (main)
Wireless M-Bus repeater AMR (battery)
8.1.2 General characteristics
Parameters
Repetition capacity
Number of repeaters
Power
Operating voltage (battery version)
Consumption max.
Operating temperature
Dimensions
Case
Radio standards
8.1.3 Radio characteristics
Module type
Wireless M-Bus
14dBm (25mW)
8.2. Implementation of Wireless M-Bus repeater AMR
8.2.1 Wireless M-Bus repeater AMR (main)
The repeater (main version) is factory configured in T1 mode (modes S1 and R1 are available on request).
For the implementation, simply connect the AC adapter, check that the operation LED power (located under the housing) is active, and the
repeater will repeat any frames RF mode concerned about 5 seconds after receipt of the initial frame.
At power up, the green LED will flash for 10/15 seconds alternately 1 second ON and 1 second OFF to indicate the correct startup of the repeat
function.
We can cascade several repeaters to extend the transmission distance.
Be careful though not to install more than 2 repeaters in the same «zone» of radio coverage as this will cause an excess of RF frame.
Caution: Do not attempt to use an AC adapter other than the one supplied with the product.
Reference
ARF7923AA
ARF7924AA
Value
T1 mode: up to 200 products repeated
S1 mode: up to 60 products repeated
R1 mode: up to 30 products repeated
Without limitation if coverage zone is respected
Main version : through ANSMANN APS300 power supply: 3Vdc (2,7Vdc min ; 3,3Vdc
max) -> maximum operating temperature : 25°C
Battery version : Li-SOCl2
3.6V nominal
150mA
-25°C / +70°C
145 x 100 x 40
IP 65
EN 300-220, EN 301-489, EN 60950, EN 13757-3 and EN 13757-4
RF power
Sensitivity (if RX adeunis®)
-110 dBm T1 mode
Firmware version
V1.0
V1.0
data rate
100 kbps
up to 600m
FR
EN
Range
Page
47
of of 50
Publicité
Table des Matières
