Taurus MOMENTS CLASSIC Mode D'emploi page 16

stable heat source, such as an electric plate,
an induction plate or a gas hob.
ANOMALIES AND REPAIR
- If the cooker is not functioning correctly, turn
of the hob immediately, place the cooker on
a flat surface and rinse slowly with cold water
to cool it and reduce the pressure. The pres-
sure cooker may only be used again once the
cause of the fault has been resolved.
Anomalies
The pressure regulating valve is
noisy and doesn´t expel steam
after heating the pressure cooker.
The safety valve expels vapor or
liquid.
The pressure valve does not rise
The lid does not close properly
FOR EU PRODUCT VERSIONS AND/OR
IN THE CASE THAT IT IS REQUESTED IN
YOUR COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE
PRODUCT
- The materials of which the packaging of this
appliance consists are included in a collec-
tion, classification and recycling system.
Should you wish to dispose of them, use the
appropriate public containers for each type of
material.
- The product does not contain concentrations
of substances that could be considered harm-
ful to the environment.
This appliance complies with Directive 97/23/
EC concerning pressure equipment.
- Take the appliance to an authorised technical
support service if problems arise. Do not try
to dismantle or repair without assistance, as
this may be dangerous.
- If any anomaly is detected, check the fo-
llowing table:
Causes
Tamponade the valve pressure
control
Tamponade tube air vent
Cooking without liquid
Tilt the stove
Clogging of the air outlet pipe
The pot is overfilled
The heat source is too strong
The lid is not fitted correctly
The heat source is not powerful
enough
The seal is dirty, damaged or
deformed
Not enough water
The lid is deformed
Solutions
Clean the pressure control valve
Remove the dirt.
Turn off the stove immediately,
remove the pressure cooker,
reduce the pressure and check
the pot.
Heat the pan on a flat, stable
stove
Eliminar la suciedad
Reducir la cantidad de llenado
Ajustar la fuente de calor al
vapor que expulsa a válvula de
presión.
Fit it correctly
Increase the heat
Clean or replace the seal
Check the amount inside the
pressure cooker
Change the lid