Uberhaus CYAA55-7 Manuel De L'utilisateur page 6

NOTE: THE HEATER WILL NOT OPERATE UNLESS IT IS PROPERLY PLUGGED INTO A
POLARIZED OUTLET AND POWERED ON.
NOTE: IT WILL NORMALLY REQUIRE APPROXIMATELY 15 MINUTES FOR THE HEATER
TO REACH ITS OPERATING TEMPERATURE.
YOUR HEATER IS EQUIPPED WITH 3-CONTROL SETTINGS AND THERMOSTAT.
Pressing Left Pressing Right
Switch to:
O
I
O
I
Thermostat Control: This heater is equipped with a thermostat function to control the temperature
output. To increase the heat output, turn the dial clockwise. To reduce the heat output, turn the dial
counter-clockwise.
Press the both power switches down at I and II for fast warm-up of a room and turn the thermostat to
maximum ( ). Once the room is comfortable, slowly rotate the thermostat counterclockwise until
the heater shuts off - you will hear a "click". The thermostat will now maintain the temperature by
cycling the heater on or off as required. Once the room is comfortable, select a lower power setting
at either [I or O] or [II and O] to reduce electrical consumption and to prevent the room from
becoming too warm. During particularly cold weather, the low setting at I or II power setting(s) may
be insufficient to maintain the temperature set at the thermostat. Select [I and II] for these periods.
To turn off heater, press both switches down to O.
SAFETY FEATURES OF THIS HEATER
Thermal Cut-Off: The heater will automatically shut off when parts of it overheat. If this occurs, turn
the heater OFF and unplug it. Inspect the unit, and remove any objects that are on or adjacent to the
unit that may cause overheating. Wait 15-20 minutes for the unit to cool down. Then plug it back into
the outlet in order to resume normal operation.
Heat Setting Control:
Combination Results
Switch to:
Unit and power light is OFF

O
No heat is produced.

Unit and power light is ON,

O
Heater is on LOW setting.

Unit and power light is ON,

II
Heater is on MEDIUM

setting.
Unit and power light is ON,

II
Heater is on HIGH setting.

6