Lutron Ivalo Finire 3 Instructions D'installation page 3

Ivalo Finiré 3" LED Downlights
Installation Instructions
Field Replace Components (optional)
WARNING: Risk of Fire or Electric Shock. May result in
serious injury or death. LED retrofit kit installation requires
knowledge of luminaire electrical systems. If not qualified, do
not attempt installation. Contact a qualified electrician.
NOTICE: Property Damage. To prevent damage or abrasions, do
not expose wiring to edges of sheet metal or other sharp objects.
Note: Do not make or alter any open holes in an enclosure of wiring
or electrical components during kit installation.
1. Turn off power.
2. Remove trim.
a. For Trimmed fixtures: Pull on flange of trim until the trim is free
(Figure 8).
b. For Trimless fixtures: Press glass upwards and pull down on
aperture of the trim until it is released from the mud ring.
3. Field replace reflector (Figure 9).
a. Remove the trim. Refer to step 1 above.
b. Hold reflector by edges. Twist counter-clockwise to unlock from
the light module.
c. Carefully remove reflector.
Note: Do NOT touch reflective surface of reflector.
d. Install new reflector. Twist clockwise to lock into light module.
4. Field replace light module (Figure 10).
a. Match LED module number on module grab plate (Figure 4) to
housing label, located inside the fixture housing.
b. Remove the trim. Refer to step 1 above.
c. Grab the module at the support and pull light module out of the
module support bracket.
d. Disconnect module from connector.
e. Connect new module to connector.
f. Secure new module into module support bracket. Make sure all
wiring is clear from the support bracket, light module, and reflector.
5. Field replace LED controller (driver) (Figure 11).
Note: Refer to LED controller (driver) replacement guide provided
with the LED controller (driver).
a. Follow steps 1, 2, and 3 to remove the trim, reflector, and light
module.
b. For Downlight fixtures or Adjustable fixtures with the tilt-lock
screw installed, remove the support bracket locking screw and
rotate the bracket away from the driver to access the controller
(driver) compartment.
c. Remove the wing nut(s) on the LED controller (driver)
support bracket.
d. Remove the LED controller (driver) from the support bracket
and pull out of the aperture (Figure 11). Disconnect the wires
from the existing LED controller (driver).
e. Transfer the wing nut(s) to the studs on the new LED controller
(driver) and connect the wires to the new LED controller (driver).
f. Insert the new LED controller (driver) into the aperture and install
it into the support bracket.
g. Install the wing nut(s) on the support bracket.
6. Restore Power.
Figure 7
Trimmed only
Figure 8
Figure 9
Reflector
Figure 10
Figure 11
Lutron LED driver
367-2578k 3 06.18.21
Trimless only
Trim
Clips
Light module
www.lutron.com/finire
610.282.7472