Lutron Ivalo Finire 3 Instructions D'installation page 2

Ivalo Finiré 3" LED Downlights
Installation Instructions
Fixture Installation
4. Cut out drywall to fit fixture aperture.
a. Round diameter: 4.6 in (117 mm). See page 6 for the template.
b. Square dimensions: 4.1 in x 4.1 in (104 mm x 104 mm). See
page 7 for the template.
c. Install the cardboard housing insert from the product packaging
to protect the LED module (Figure 2 on previous page).
5. Install mud ring (Trimless only) (Figure 3).
a. Remove ceiling material to allow access to housing mud ring
screw locations. If desired, use cutout template at end of
installation guide.
b. Insert provided screws into holes in mud ring and screw into
housing.
c. Use screws to level the mud ring to the ceiling.
d. Ensure screws secure mud ring flush to drywall.
e. Apply plaster up to rim of mud ring.
Note: Use fiber mesh provide to increase durability of plaster joint.
f. Smooth plaster to blend with ceiling.
6. Install LED module.
Note: DO NOT touch the inside of the reflector or the LED.
a. Match LED module number on module grab plate (Figure 4) to
housing label, located inside the fixture housing.
b. Connect LED module to housing. For types XX, NS, HO, HP,
press in the red button on the connector to lock the connector
in place.
Note: Connectors are specific to housing / module compatibility.
c. Install module by pressing it up into the module support bracket.
Note: Module must be installed into the keyway (Figure 4) of the
module support bracket.
7. For Adjustable fixtures, rotate the fixture to the desired location
(Figure 4).
a. Loosen rotation-locking thumb screw.
b. Aim fixture by rotating the module support bracket to the
desired position.
c. Tighten thumb screw.
8. For Adjustable fixtures, adjust the tilt position of the fixture by
moving the module support bracket along the track (Figure 5).
Optional: Lock tilt position with tilt lock thumb screw (Figure 4).
Note: For Infinite Adjustable fixtures, turn tilt adjustment screw
with Lutron supplied 9/64 in hex tool (Figure 6).
9. Install the trim (Figure 7 on next page) by pushing the trim into
opening until clips engage on sides. Use a damp cloth to clean the
trim / lens.
10. Restore power.
(continued)
Figure 3
Mud ring
Rim
Figure 4
Keyway
Module
support
bracket
Module
grab
plate
Reflector
Note: Enclosure removed for visual clarity. Standard Adjustable
fixture shown.
Figure 5
Track
Figure 6
Note: Tilt adjustment screw
available for Infinite Adjustable
fixtures only
DETAIL C
SCALE 1 : 1
367-2578k 2 06.18.21
Drywall
Fiber
Fiber
mesh
mesh
Plaster
DETAIL C
SCALE 1 : 1
DETAIL C DETAIL C
SCALE 1 : 1 SCALE 1 : 1
Light
module
Adjustable
assembly
Tilt lock
thumb screw
Rotation
lock thumb
screw
Tilt adjustment
Tilt adjustment
screw
www.lutron.com/finire
610.282.7472
C
C C