Gigabit Ethernet Rackmount Switch
Thank you for purchasing the Intellinet Network Solutions Gigabit Ethernet
Rackmount Switch, Model 524148 (16-port) or 524162 (24-port). For specifications,
go to intellinet-network.com.
CONNECTIONS
• All ports on the switch support Auto-MDI/MDI-X functionality, so you can use straight
or crossover UTP/STP cables to connect the RJ45 ports to PCs, routers, hubs, other
switches, etc.
LED Status Operation
PWR On
Power on
Off
Check connection; turn power on
LNK/ On
Valid port connection
ACT Blinking Data transmitted/received
Off
No link established
• The LED indicators — Power, Link/Activity — make monitoring and troubleshooting
easier. If a status LED doesn't indicate a link or activity, check the corresponding
device for proper setup and operation.
• Use the included power cable to connect the receptacle on the back of the switch to
a power outlet, and confirm that the Power LED lights.
PLACEMENT
Prior to use, it is recommended that the switch be placed/positioned:
• on a level surface that can support the weight of the switch (and any other items
that need to be considered);
• with a minimum of 25 mm (approx. 1") of clearance on the top and sides for
adequate ventilation;
• away from sources of electrical noise: radios, transmitters, broadband amplifiers, etc.;
• where it cannot be affected by excessive moisture; and
• within 100 m (approx. 328') of network devices it's to be connected to.
Rackmount
The switch includes brackets and screws for optional rack mounting.
1. Disconnect any cables from the switch.
2. Position a bracket over the mounting holes on one side of the switch and secure it
in place with screws.
3. Repeat Step 2 on the other side of the switch.
4. Position the switch in the rack and screw the brackets to the rack.
5. Reconnect any cables.
2
ENGLISH
Link/
Act
Power
English
Model 524148, 16-Port