General Operation; Information Banner - Grandin LGT32V510 Mode D'emploi

After then, the active antenna selection OSD appears
on the screen:
By pressing " " or " " buttons, set active antenna
mode as on or off.
If an active antenna is connected to your TV, you can
select this option as On. Antenna power should be
"Off" when standard antenna is used instead of the
active antenna. See "Con guration Menu" in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the "Yes" or "No" option, highlight the item
by using " " or " " buttons and press OK button.
The IDTV will automatically tune to the transmission
channels, searching for digital terrestrial TV broadcasts
and displaying the names of channels found. This
process will take a few minutes. To cancel searching,
you can press MENU button at any time during the
process. The following OSD will be displayed during
the automatic search:
After Automatic Search is completed, the following
message will be displayed, asking for sorting option.
If you select "YES", programme list will be sorted
according to LCN (logical channel number). Select
"NO" for using frequency sort. (This feature is available
for only Germany,Austria and Italy country option).
After this operation, the following menu will appear on
the screen, asking for analog channel search:
02_[GB]_MB36_HDIDTV-MPEG4_BRONZE8_32855W_3900UK_10068346_50166694.indd 49
To search for analogue channels, select "Yes". TV
switches to the analogue TV mode. A menu will be
displayed to search for analogue channels .
Set Language item by pressing " " or " " button.
Press " " or " " button to highlight Country item and
then use " " or " " to set. Press " " or " " button to
highlight TXT. Language. Set TXT Language by using
" " or " " button. To cancel, press the BLUE button.
When  nished, press OK or RED button to continue
and the following OSD will be displayed:
After automatic tuning is  nalized, a programme list
will appear on the screen. In the programme list you
will see the programme numbers and names assigned
to the programmes.
If you do not accept the locations and/or the names
of the programmes, you can change them in Program
table. For details, see the section, "Program table".

General Operation

Pressing the ''DTV/USB'' button at any time while
watching television programmes will switch the TV
set to the digital terrestrial television broadcasting.

Information Banner

• Whenever you change the channel using the P + or
P - button or numeric buttons, the TV displays the
broadcast picture along with an information banner
at the bottom of the screen. This will remain on the
screen for approximately a few seconds.
• The information banner can also be displayed by
pressing the
the TV. Pressing
banner.
If the selected channel is locked, you must enter
the correct four digit key to view the channel. In this
case, a dialog box asking for the lock key will be
displayed:
English - 49 -
button at any time while watching
button again removes the
02.04.2010 19:35:25