Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Mounting the handshower
3
Installation de la
douchette
handshower
rubber washer
rubber gasket
rubber washer
metal washer
chrome
hose
A. Insert the flangle with threaded rod
onto the hole on your deck. Secure
with the tie down kit (washer & nut) as
shown. (Fig.5)
B. Insert the chrome hose onto the hole
of your base flange as shown.
C. Take the handshower and the
chrome hose, connect together with
rubber washer. Tighten firmly.
last revision: 09/13/2022
4
Hoses connecting
Installation du drain
mixer
base
flange
mix wa-
ter hose
metal
nut
Fig.5
A. Take the extension hose and
mount the 1/2" female end into the
bottom of the shank as shown. Con-
nect the other end of the extension
hose to the 3/8" end of the chrome
hose. (Fig.6)
B. Next connect the mix water hose
into the side outlet of the shanks as
shown.
C. Finally, connect the hot & cold flex-
ible hose to the water supply lines.
madison 86013
3-piece tub filler with handshower
robinet de bain 3 morceaux avec douchette
5
Connection checks
Vérification des raccordements
A. When the connections are made,
turn on the mixer. Check all joints for
leaks. Tighten as needed.
B. Flush out both lines again before
you thread your aerator back into the
spout.
C. Turn on the mixer and with the wa-
ter now running from the spout, pull
chrome
shank
up on the diverter to verify that the
hose
water is now diverted properly to the
hand shower. Now turn off the mixer
and the spring loaded diverter will
extension
return back to spout.
hose
Only use the diverter to divert from
the spout to the hand shower. Do not
divert back and forth with the water
hot & cold
running. Use only as instructed.
water supply
Fig.6
5
aquabrass.com
Publicité
Table des Matières
