R&G RSET017BK Instructions De Montage page 6


Please check operation of the brake before riding.
BRAKE SIDE

Undo and remove the two bolts holding the heel guard and master cylinder as arrowed in
picture 5.

Undo and remove the two bolts holding the original footrest to frame while supporting the
footrest as shown in picture 6.
Page | 6

Unclip the spring and remove the original brake light sensor as arrowed in picture 7.

Disconnect the master cylinder connector arrowed in picture 8 and replace with the female
ball joint as shown in picture 9.

Fit the alternative master cylinder mounting bracket (item 13) in place as shown in picture 13.
Ensure the correct lever is installed for your bike – the lever's tail should angle downward for

'07-'08 and upwards for '09-

Fit the brake assembly into position using the two bolts and spacers as shown in picture 10.

Connect the ball joint and brake lever together using the spacer as shown in picture 11 (please
ensure to use the nyloc nut to secure).

Secure the master cylinder using the two bolts as arrowed in picture 12 (please ensure the
master cylinder pressure shaft is directly in line with master cylinder as shown in picture 12.

PLEASE NOTE FAILURE TO DO THIS MAY RESULT IN BRAKE FAILURE
AND/OR JAMMING OF BRAKES. Ensure the rearsets have the correct bracket for your
model of bike – For Kawasaki ZX6R '07-'08 use item #13. For Kawasaki ZX6R '09- use item
#9

Adjust the new rear set for comfort and position using the two bolts and sub plate arrowed in
picture 13.

Tighten all bolts and lock-nuts.

Please check operation of the brake before riding.
BRAKE LIGHT SENSOR SWITCH

Remove the bolt holding the banjo fitting to end of the master cylinder and replace the bolt
with the brake light sensor switch (item 6) using the aluminium sealing washers supplied
(item 7) as arrowed above. PLEASE NOTE YOU WILL HAVE TO BLEED THE
BRAKING SYSTEM.

We recommend cutting the original wiring and using bullet connectors to connect the brake
light sensor switch wires to the original wiring.

Please check operation of brakes and brake light before riding.
Because of the complexity and inherent dangers involved in undertaking any work
involving the braking system we strongly recommend a qualified mechanic fits/or checks
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
2007-2008
ON NON ABS MODELS
after the fitting of this product.
R&G Racing
www.rg-racing.com Email: info@rg-racing.com