Publicité
Les langues disponibles
Les langues disponibles
8. Reinstall door hinges
Using the screws you set aside, reinstall hinge B (removed from
the lower-left corner of the door) in the upper-right corner. Tighten
all screws.
Using the screws you set aside, reinstall hinge A (removed from
the upper-left corner of the door) in the lower-right corner. Tighten
all screws.
9. Replace hinge covers
Replace the door hinge covers.
10. Transfer strike plate
®
Using a T20
star driver, remove the two screws securing the strike
plate and move the strike plate from the left side of the dryer
cabinet to the right side, securing it with the removed screws.
Troubleshooting
See your Owner's Manual or visit our website and reference Frequently Asked Questions to possibly avoid the cost of a service call.
11. Hang door
Hang the door on the unit by placing set pin in dryer cabinet hole
and sliding door down. Using a Phillips screwdriver, install screws 1
and 3 and then screws 2 and 4. Tighten all hinge screws.
12. Install cover from accessory kit
Install the plastic cover from the accessory kit into the space where
the lower hinge was removed. Place the plastic hinge covers over
the exposed hinges.
3
Publicité
