Important Safety Instructions; Fcc Statement - Sylvania SDVD9319 Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS

of the glass. In the same way, moisture may condense on the optical pick-up lens inside this unit,
one of the most crucial internal parts of the DVD player.
Moisture condensation occurs during the following cases:
● When you bring the DVD player directly from a cold place to a warm place.
● When you use the DVD player in a room where you just turned on the heater, or a place where the
cold wind from the air conditioner directly hits the unit.
● ln summer, when you use the DVD player in a hot and humid place just after you moved the unit
from an air conditioned room.
● When you use the DVD player in a humid place.
Do not use the DVD player when moisture condensation may occur.
● lf you use the DVD player in such a situation, it may damage discs and internal parts. Remove the
disc, connect the AC/DC Adaptor to the DVD player and the wall outlet, turn on the DVD player and
leave it ON for two or three hours. After two or three hours, the DVD player will have warmed up
and evaporated any moisture.

FCC STATEMENT:

Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment."
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help."
All manuals and user guides at all-guides.com
5