Power Source - Sylvania SDVD9319 Mode D'emploi

POWER SOURCE

The unit has a built-in DC
Charging by supplied Wall Power Adapter: Charging by supplied Wall Power Adapter:
Connect the small plug from the supplied wall power adapter to the DC IN Jack on the right of unit.
Connect the wall power adapter to the wall outlet having
During charging, the Red Indicator will turn on. When finished, it will turn off.
NOTE:The wall power adapter is intended to be correctly orientated in a vertical or floor mount position.
Your battery will last longer if you follow these simple guidelines for caring for and storing it.
Recharge and store the device within the temperature range of 5°C~35°C (40°F~95°F).
Do not overcharge (longer than 24 hours). Excessive charging or
battery's life.
Battery life naturally shortens slowly over time.
Charging by the supplied Car Power Adaptor:
1. Connect to the cigarette lighter socket of a vehicle that has a 12V battery as the figure below.
It is NOT compatible with It is NOT compatible with
2. This is a special negative grounded
Car Adapter. Using this Car Power
Adapter with a plus grounded car
can cause malfunction.
3. Do NOT plug in the Car Power Adapter
until the car ignition is turned on.
4. Disconnect the Car Power Adapter from the
cigarette lighter and the unit after use.
To DC IN Jack on the unit
All manuals and user guides at all-guides.com
7.4V Lithium-ion rechargeable battery.
a vehicle that has a 24V battery. a vehicle that has a 24V battery.
11
Recharge it as follows:
AC 100-240V~; 50/60Hz.
discharging may shorten the
To the cigarette
lighter socket