Stereo Setup - Elipson HERITAGE XLS15 Manuel D'utilisation

EN EN
III. STEREO SETUP
The Heritage XLX15 loudspeakers have been designed to reproduce all
types of music as accurately as possible, provided that a few rules should
be followed to optimize performance and achieve a realistic sound image.
Ideally, the speakers should be placed symmetrically in front of the listening
position to form an equilateral triangle. The cabinets should be placed on
the floor or on an optional dedicated stand, at the same distance from the
rear wall and from the adjacent side surfaces.
In order to optimize the setup of the speakers in your listening room, we
recommend the following tests:
Above all, you should avoid positioning the loudspeakers in the corners of
your room. The result will be an artificial increase in the level of bass, masking
the speed and details of this range. Otherwise feel free to use the port plug
When inserting the port plug into the loudspeaker, do not push it too far.
Otherwise the port plug may fall into the speaker cabinet.
First, adjust the spacing of the two speakers in order to find the realistic
balance between a wide sound image (wide apart speakers) and a sound
image respecting the punctuality of the voices (close speakers).
Secondly, move the speakers away from the rear wall by steps of 10 cm to
find the balance between the depth of the sound image (far from the back
wall) and the level of the extreme low frequencies (close to the back wall).
Finally, adjust the loudspeakers orientation by turning them gradually toward
the center of the listening area. If you leave the speakers parallel, you may
want to bring them closer together, if you orient them more than 30°, you
may increase their spacing.
14
d
d
d
~60°
15