Uline H-5487 Mode D'emploi page 2

1. Lock casters. Place lock washer over caster stem
and screw into base. (See Figure 1)
Figure 1
2. Insert upright assembly into base with cable
management holes facing back of unit. Fasten in
place with four base bolts. (See Figure 2)
Figure 2
Back
Front
3. Snap bolt cover into place. (See Figure 3)
Figure 3
PAGE 2 OF 15
ASSEMBLY
4. Adjust uprights to desired height using plunger
buttons. (See Figure 4)
Figure 4
Assistance
Required
NOTE: Never adjust height with the cables
connected or flat screen mounted.
5. Unscrew pre-installed bolts from crossbar. Slide
crossbar into position and screw bolts back into
place. (See Figure 5)
Figure 5
1
3
2
0521 IH-5487